top of page
Search

Heat, Hail and Wind: Why 2026 Shade Specifications Are Getting More Specific

Nov 2
3 min read

For twenty years a shade specification was one number: 70 percent. In 2026 buyers are sending site data with the enquiry, including wind speed, hail history and roof span, because a net that was correct for a site in 2015 is failing on the same site now. Here is what changed and how to specify against it.


Heat: the number that matters is under the net, not above it


Measured air temperature under a shade net is not a function of shade rate alone. It depends on how much of the intercepted radiation the fabric re-radiates, and on how much air still moves through the canopy.


Tape construction intercepts more radiation per square metre, so it runs cooler at midday than monofilament at the same nominal percentage, typically a few degrees, and more on a still day. Monofilament lets more diffuse light through, which is better for crops that respond to light quality rather than light quantity.


The specification consequence: a buyer optimising for temperature should specify construction and gram weight, and treat the percentage as a secondary number.


Hail: shade net is not hail net, and mixing them up is expensive


A knitted shade net will stop small hail and will shred under large hail. If a site has a real hail history, the answer is a hail net over the crop with the shade net above it, or a hail-rated woven panel, not a heavier shade net.


What decides it is hail stone size, not frequency. Pea-sized hail is a nuisance the shade net survives. Golf-ball hail needs a hail net, and the shade net should sit above it so the hail net takes the impact.


Wind: eyelet spacing is the number that gets skipped


Design wind pressure follows q = 0.613 x V squared. For reference, 20 m/s is about 245 Pa, 30 m/s about 552 Pa and 40 m/s about 981 Pa. A knitted net is porous, so only part of that pressure acts on the fabric, usually 30 to 50 percent depending on aperture, but the load transfers entirely to the eyelets, the hem and the fixing line.


The specification: 30 cm eyelet spacing with a double-stitched hem on a wind-exposed side wall; 50 cm with a heat-sealed tape edge on a protected roof. Getting this wrong is the single most common cause of a shade house coming down, and it costs nothing to specify correctly at quotation.


Flat roofs and wide spans: where tape wins


Above about 8 m span, monofilament sags between supports and the sag grows each season, which changes both the shade profile and the wind loading. Tape construction at 120 to 180 g/m2 holds tension across wide spans, which is why car parks, livestock shade and wide greenhouse roofs are almost always tape.


Frequently asked questions


Can one net handle shade and hail?


Not well. A shade net stops small hail but tears under large stones, and a hail net alone gives no shade control. Sites with real hail exposure use two layers: hail net below, shade net above.


How do I calculate wind load on a shade house roof?


Use q = 0.613 x V squared for design pressure, then apply 30 to 50 percent to a porous knitted net and transfer the result to the eyelet and hem design. We confirm the fixing interval from your site wind speed and span.


Does a higher gram weight always mean a longer life?


No. Gram weight affects tensile strength and tension holding, but UV stabilisation determines how many seasons the net survives sun exposure. A heavy net with poor stabilisation fails before a lighter, well-stabilised one.


Tell us the site and we will confirm the interval


Tell us the site wind speed, the span between fixing lines and the crop. We will confirm the construction, gram weight and eyelet interval rather than leave it to the installer.

 
 
 

Recent Posts

See All

Comments


bottom of page